Redback SH4600 - Page 13

Redback Technologies
GUI- 003 Knowledge Base- Resetting your Redback Inverter
Audience: Home owner Installer .
Version 1.0 - 27/07/2018 - Page 13 of 16
12.
Message “Important. Wi-Fi setup is
done…” will appear (8-12).
STOP! DO NOT PRESS OK YET
Before finishing you must disconnect
your iOS device from the inverter Wi-Fi
and connect it to your home network,
as described below.
Figure 8-12 Figure 8-13 Figure 8-14 Figure 8-15
13.
Connect your device to your home
network
• Swap back to iOS Settings (8-13)
• Touch Wi-Fi (8-14)
• Select your home Wi-Fi network
from the list (8-15)
• Enter your Password if requested
The inverter and your device are now
connected to the home network.
14.
Return to the Redback App and touch
OK (8-16)
Figure 8-16 Figure 8-17 Figure 8-18 Figure 8-19
15.
The message “Important. Do you want
to connect to an inverter on your local
Wi-Fi etc” may appear.
Touch Local to continue (8-17).
A reminder appears (8-18). Touch OK
to acknowledge and continue.
Touch Find existing inverter.
Redback inverters connected to your
home network are listed.
16.
Select your serial number from the
list.