Item Description Use Article number
1 Removal tool for
the ball bearing
To remove ball bearings. 502 50 18-01
2 T-handle Torx,
T27
To loosen or remove Torx screws. 502 71 27-02
3 Carburetor ad-
justment tool
To adjust the idle speed screw on the carburetor. 501 60 02-03
4 Carburetor ad-
justment tool
To adjust the high speed needle and low speed needle on the carbu-
retor.
530 03 55-60
5 Removal tool for
the drive gear
To remove the drive gear. 505 38 13-08
6 Assembly pliers To repair the spark plug cable. 502 50 06-01
7 Piston stop To stop the movement of the piston. 522 43 18-01
8 Test spark plug To do a spark test. 502 71 13-01
9 Fuel filter hook To pull the fuel filter out of the fuel tank. 502 50 83-01
10 Removal tool for
the piston pin
To remove the piston pin. 505 38 17-05
11 Air gap gauge,
0.3 mm
To measure the distance between the flywheel and the ignition module. 502 51 34-02
12 Air gap gauge,
0.5 mm
To measure the electrode gap on the spark plug. 502 51 91-01
13 Crankshaft as-
sembly sleeve
To assemble the crankshaft. 577 90 21-01
14 Flywheel remov-
al tool
To remove the flywheel. 577 90 66-01
15 Piston assembly
tool
To assemble the piston. 502 50 70-01
16 Tachometer To measure RPM. 502 71 14-01
17 Pressure tester To do a pressure test. 531 03 06-23
18 Grease To lubricate the gear housing. 503 98 96-03
19 Detergent To clean the air filter. 505 69 85-70
20 Air filter oil To lubricate the air filter. 531 00 60-76
21 UL 21 spray To lubricate the cutting unit. 544 14 21-01
1351 - 002 - 25.11.2020 Servicing tools - 11
To Next Page
Loading...
