4. Put the crankshaft in the crankcase half on the
flywheel side. Lubricate the stub axle with some
drops of oil and carefully move the crankshaft into
the ball bearing.
5. Install the gasket to the clutch side of the crankcase
half. Lubricate the crankshaft pin with some drops of
oil and move the crankcase half on the clutch side
into position. Tighten the 3 crankcase screws in
turns. Make sure that the crankshaft can rotate
easily.
1351 - 002 - 25.11.2020 Repair instructions - 43
To Next Page
Loading...
