In the App, the vacuum-mop will automatically save the updated map
after quick mapping or completing cleaning and successful recharging.
After a map is completed successfully, you can split or merge zones or
name any room in the App.
Memory map
Vibration mopping mode is adopted by default when mopping the floor,
which can enhance mopping effect. The mode can be turned off in the
App.
Vibration mopping mode
In the App, a variety of cleaning modes and suction gears can be
selected.
Model/level selection
9
2. Configure the network
Connection with APP
1. Scan the QR code below or search for “Redroad” in the App store
to download and install the App.
Select and connect the device network according to the tips on the App page.
• Wi-Fi binding with Android mobile phone
• Wi-Fi binding with IOS mobile phone
Password
WiFi-2.4G
Enter the Wi-Fi setting page of the
mobile phone and select the
corresponding product hot spot until
the connection is successful; return to
the App interface, click “Next” to
complete the connection according to
the tips.
Note: Only Wi-Fi network in 2.4GHz band is supported.
Press and hold the “ + ” buttons for 7s to configure the network
Operation
3. Add the machine in the App interface and enter the Wi-Fi password
to connect
Press “ ” of the vacuum-mop for 3s, indicator light is on and the
vacuum-mop is on.
When the vacuum-mop is not charged and paused, press “ ” for 3s
to make it power-off.
Power-On/Off
In the power-on state, press the “ ” button for a short period of time,
and the vacuum-mop starts to work.
Cleaning
When the vacuum-mop is running, press the “ ” button of the
vacuum-mop for a short period of time to stop cleaning, and then press
the “ ” button for a short period of time again to continue cleaning.
Pause
To Next Page
Loading...
Need help?
General
