HOW TO USEA CUSTOM PROGRAM
insert the key into the console.
See HOW TO TURN ON THE POWER on
page 12,
Select a custom program.
To sebct a custom program, press the Custom
Programs button repeatedUy until "P-15" or "P-16"
appears in the right dispUay,
When a custom program is sebcted, the bft dis-
pUaywHUflash the maximum incline setting of the
program for a few seconds, and the right dispUay
wHUflash the maximum speed setting, The bft dis-
pUaywHUthen show how bng the program wHUUast,
in addition, the first ten speed settings of the pro-
gram wHUappear in the matrix in the bft display,
Note: if only three coJumns of indicators ap_
pear, see HOW TO CREATE A CUSTOM PRO-
GRAM on page 16.
Press the Start button or the Speed increase
button to start the program.
A moment after the button is pressed, the tread-
mill will automatically adjust to the first speed and
incline settings that you programmed previously,
Hold the handrails and begin walking,
Each program is divided into several one-minute
segments, One speed setting and one incline set-
ting are programmed for each segment, The
speed setting for the first segment wiii be shown in
the flashing Current
Current Segment
matrix, (The incline set- Column
tings are not shown in
the matrix,) The speed
settings for the next
several segments will
be shown in the
columns to the right,
When only three seconds remain in the first seg-
ment of the program, both the Current Segment
column and the column to the right wiii flash, a se-
ries of tones wiii sound, the speed setting and the
incline setting will flash in the displays, and aii
epeed sett/ngs will move one ooldmn to the/e_Z
The speed setting for the second segment will then
be shown in the flashing Current Segment column
and the treadmill will automatically adjust to the
second speed and incline settings that you pro-
grammed previously,
The program wiii continue until the speed setting
for the last segment is shown in the Current
Segment column and the last segment ends, The
walking belt wiii then slow to a stop,
if desired, you can redefine the program while
using it, To change the speed or incline setting
during the current segment, simply press the
Speed or Incline buttons, When the current segment
ends, the new setting will be saved in memory, To
increase the Jength of the program, first wait until
the program ends, Then, press the Start button, and
program speed and incline settings for as many ad-
ditional segments as desired, When you have
added as many segments as desired, press the
Stop button twice, To decrease the bngth of the
program, press the Stop button twice at any time
before the program ends,
To stop the program at any time, press the Stop
button, The time wiii begin to flash in the left dis-
play, To restart the program, press the Start but-
ton or the Speed increase button,
Fottow your progress with the displays.
See step 5 on page 12,
Measure your heart rate if desired.
See step 6 on page 13,
Turn on the fan if desired.
See step 7 on page 13,
When you are finished exercising, remove the
key from the consote.
See step 7 on page 15,
17
To Next Page
Loading...
