PROBLEM: The walking belt is off-center or stips when walked on
SOLUTION: a,
if the waIMng belt is off-center, first remove the key and
UNPLUG THE POWER CORD, If the walking belt has
shifted to the teft, use the allen wrench to turn the Heft
rear roller boit cHockwbe 1/2 of a turn; if the walking belt
has shifted to the right, turn the boit countercHockwbe
1/2 of a turn, Be carefui not to overtighten the waiking bent,
Then, plug in the power cord, insert the key, and run the
treadmHi for a few minutes, Repeat until the waiMng bent is
centered,
b,
if the walking belt sfips when walked on, first remove the
key and UNPLUG THE POWER CORD, Using the allen
wrench, turn both rear roller bolts clockwise 1/4 of a turn,
When the walking belt is correctly tightened, you should be
abie to rift each edge of the waiking bent 3 to 4 inches off
the waiking piatform, Be carefui to keep the waiking bent
centered, Then, piug in the power cord, insert the key, and
waik on the treadmili for a few minutes, Repeat untii the
waiking bentis properiy tightened,
PROBLEM: The disptays of the consote do not function properly
SOLUTION: a,
Remove the key from the console and UNPLUG THE
POWER CORD. Next, remove the screws from the hood
and carefuliy remove the hood, Locate the Reed Switch
(17) and the Magnet (12) on the Heftside of the Pulley (11),
Turn the Pulley untii the Magnet is aligned with the Reed
Switch, Make sure that the gap between the Magnet
and the Reed Switch is about 1/8". if necessary, ioosen
the indicated Screw (44), move the Reed Switch slightly,
and then retighten the Screw, Re-attach the hood and run
the treadmill for a few minutes to check for a correct speed
reading,
1/8"[
44-'-
17 j
Top
View
PROBLEM: Television reception is poor
SOLUTION: a, For the television to operate properly, good reception is necessary, if you are using an antenna,
make sure that it is properly connected and adjusted for optimal reception, (See HOW TO CON-
NECT AN ANTENNA on page 9,)
b, Check for the problems listed below and follow the applicable instructions,
ignition (black spots or horizontal streaks that appear or a picture that flutters or drifts)--Usually
this is caused by interference from automobile ignition systems, neon lamps, electric drifts, or
other electric appliances, Try changing the position of the treadmill or other electric appliances to
correct the problem,
Ghosts--Ghosts are caused by the television signal following two paths--one is the direct path
and the other is reflected from tall buildings, hills, or other objects, Change the direction or posi-
tion of the antenna to improve reception,
Blue Screen--if the treadmill is located in the fringe area of a television station where the signal is
weak, the picture may be of poor quality or a blue screen may appear, if the signal is weak, it may
be necessary to install an external antenna to improve the picture,
Note: if one of these symptoms appears when the cable from a CATV company is connected, the
symptom may be caused by the local company broadcast,
24
To Next Page
Loading...
