Reed Instruments R8070SD - Data Hold; Peak Hold; Recording Maximum and Minimum Readings

10
 
or position it on a tripod for long-term monitoring. Point the
microphone in the direction of the noise to take a measurement.
Note: Direct contact with strong winds or blowing air on the microphone
may cause measurement errors. These effects can be reduced by using
the included windshield ball.
Data Hold
1. While taking a measurement, press the HOLD button to freeze the
current readings on the display.
 
3. Press the HOLD button again to resume normal operation.
Note:POWER
button are disabled.
Peak Hold
1. While taking a measurement, press the LOGGER button to capture
and freeze a noise peak.
2. While in this mode a PEAK symbol will appear and the displayed
reading will only change when a higher sound peak is registered.
3. Press the LOGGER button again to resume normal operation.
Recording Maximum and Minimum Readings
1. Press the REC button to enter recording mode as indicated by

and minimum readings.
2. While in recording mode:
A) Press the REC

B) Press the REC button again and the minimum value will appear
on the display as indicated by "REC MIN".
 
hold the REC button for two seconds.
Note: When in recording mode the POWER button is disabled and the
meter cannot be turned off.
continued...
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com