12
Setting Data Decimal Format (dEC)
Numeric formats vary in different countries. By default the meter is set to
bASIC mode where a decimal point is used to separate units, (i.e. 20.00).
The European format uses a comma (i.e. 20,00) to separate units. To
change this setting, follow steps 1 and 2 when "dEC" appears on the LCD.
and buttons to select between bASIC and Euro.
2. Press the ENTER
Note: At any time, you can press the ESC
and resume normal operation.
Enabling/Disabling Auto Power OFF (PoFF)
Follow steps 1 and 2 when "PoFF" appears on the LCD.
and buttons to select between ON (enabled) or OFF
(disabled). With the Auto Power OFF feature enabled, the meter will
automatically switch OFF after 10 minutes of inactivity to preserve
battery life.
2. Press the ENTER
Note: At any time, you can press the ESC
and resume normal operation.
Enabling/Disabling the Beeper Sound (bEEP)
Follow steps 1 and 2 when "bEEP" appears on the LCD.
and buttons to select between ON (enabled) or
OFF (disabled).
2.
Press the ENTER
Note: At any time, you can press the ESC
and resume normal operation.
Setting the Data Logging Sampling Rate (SP-t)
Follow steps 1 and 2 when "SP-t" appears on the LCD.
and
5, 10, 30, 60, 120, 300, 600, 1800, and 3600 seconds.
2. Press the ENTER
Note: At any time, you can press the ESC
and resume normal operation.
continued...
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com
To Next Page
Loading...
