Reed Instruments R8070SD - Formatting the SD Card (Sd F); Checking Time and Date; Checking Sampling Rate; Data Logging

13
Formatting the SD Card (Sd F)
Follow steps when "Sd F" appears on the LCD.
  and buttons to select YES to format the card. Select
NO to abort.
2. Press the ENTER button to conrm selection.
3. Press the ENTER button again to re-conrm.
4. The meter will format the SD card and automatically return to the
Setup menu when formatting is complete.
5. Press the ESC
normal operation.
Note: It is recommended that new SD cards should be formatted prior to
rst use. If the formatting process fails, the meter will display Sd -E-.
Checking Time and Date
During normal operation, hold the TIME CHECK button to display the
year, month, day, hour, minutes and seconds.
Checking Sampling Rate
During normal operation, hold the SAMPLING CHECK button to view the
selected sampling rate.
Data Logging
Data Recording Modes
Manual Data Logging: Manually log up to 99 readings on a SD
memory card (see Manual Data Logging Mode section for details).
Automatic Data Logging: Setup the meter parameters in order to
automatically log data on a SD memory card. The number of data points
is limited by the size of the memory card.
Note:

The card must be inserted with the label side facing the rear of the meter.
continued...
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com