Reed Instruments R8070SD - Backlight; Setup Mode; Setting the Time and Date (Date)

11
Backlight
After powering the meter ON, the LCD Backlight will turn on automatically.

Setup Mode
1. Press and hold the SET button for 2 seconds to enter Setup Mode.
2. Press the NEXT button continuously to scroll through the
following parameters.
Parameter Description
dAtE Set the time and date
dEC Set the decimal format (Basic (20.00) or European (20,00))
PoFF Enable or disable the auto-power off function
bEEP Turn the beeper on or off
SP-t Set the data logging sampling rate
Sd F Format the SD memory card
3. Once the appropriate parameter has been selected follow the
associated instructions below.
Note:
pressed within 7 seconds.
Setting the Time and Date (dAtE)
1. Press the ENTER button when "dAtE" appears on the LCD.
  and 
3. Press the ENTER button to conrm selection.
4. Repeat steps 2 and 3 for month, day, hour, minute and seconds as

5. After each value has been selected and conrmed, the meter will

Note: At any time, you can press the ESC
and resume normal operation. The internal clock will keep accurate time
when the meter is powered off. When new batteries are installed the clock
will have to be reset.
continued...
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com