EasyManua.ls Logo

Reely NEW2 BL - A) Removing the Car Body; B) Installing the Receiver Aerial Cable; Charging the Drive Battery for the Vehicle; Commissioning

Reely NEW2 BL
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
40
8. Charging the Drive Battery for the Vehicle
Item no. 2588892 includes a 2-cell LiPo drive battery and a LiPo charger. Observe the operating instructions of the
charger for this.
The rechargeable drive battery is delivered uncharged and must be charged. Several complete discharge and
charge cycles are necessary before the drive battery delivers its maximum power.
If you are still using "old" NiCd drive batteries, they should be run "empty" at all times, because repeated charging
of a "half-full" NiCd drive battery can cause a memory effect. That means that the drive battery loses its capacity; it
no longer releases all of its stored energy and the driving time is decreased.
For rechargeable batteries with NiMH or LiPo technology, recharging partially discharged rechargeable batteries
does not cause any problems. Previous discharge is usually not required.
High-quality rechargeable drive batteries not only have a higher capacity, which allows you to drive your model car
much longer, but also deliver a higher output voltage for extreme situations. This gives the motor more power and
results in better acceleration and higher speed.
Rechargeable batteries heat up during charging/discharging (driving the vehicle). Wait until the rechargeable batter-
ies have reached room temperature before charging them. The same applies after the charging procedure. Do not
usetherechargeablebatteryinthevehicleuntilithascooleddownsufcientlyafterthechargingprocess.
Only use a charger suitable for the battery type used (e.g. LiPo).
Remove the drive battery from the vehicle for charging.
9. Commissioning
a) Removing the Car Body
Pull the safety clips out and take off the car body upwards.
b) Installing the Receiver Aerial Cable
Guide the aerial cable through the aerial tube (A) and plug
it into the respective holder (B) at the top of the vehicle.
For a wide range, the aerial needs to protrude from the
vehicle as vertically as possible.
Never coil the aerial cable! This greatly reduces the range.
Ensure that the aerial cable is not damaged. Never short-
en the aerial cable!

Table of Contents

Related product manuals