MOSAIC M1S COM MASTER MODULE
IMPORTANT SAFETY INSTRUCTIONS
This safety alert symbol indicates a potential personal safety hazard.
Failure to comply with instructions bearing this symbol could pose a very
serious risk to personnel.
➔ This symbol indicates an important instruction.
To guarantee a correct and safe installation and operation of the
module, it is necessary to consult the instruction manual available in
download area on the ReeR website.
The MOSAIC is built to the following safety levels: SIL 3, SILCL 3, PL e,
Cat. 4, Type 4 in accordance with the applicable standards. However, the
definitive SIL and PL of the application will depend on the number of
safety components, their parameters and the connections that are
made, as per the risk analysis.
Read the "Applicable Standards" section carefully.
Perform an in-depth risk analysis to determine the appropriate safety
level for your specific application, on the basis of all the applicable
standards.
Programming/configuration of the MOSAIC is the sole responsibility of
the installer or user.
The device must be programmed/configured in accordance with the
application-specific risk analysis and all the applicable standards.
Once you have programmed/configured and installed the MOSAIC and
all the relative devices, run a complete application safety test. See
"TESTING the system", in the MOSAIC manual available online for free
download.
Always test the complete system whenever new safety components are
added. See "TESTING the system", in the MOSAIC manual available
online for free download.
ReeR is not responsible for these operations or any risks in connection
therewith.
To Next Page
Loading...
Need help?
General
