Rev 3.1 32 | P a g e
4.12 Post Load Test Inspection Checklist Form
Avg No of Transfers / Year
Original Inspection record filed in
Load Plate (Critical Part) - Visually inspect in situ for any signs of wear, cracks, deformation or other
damage.
Load Plate Safety Bolts (Critical Part) (Consumable)- Visually inspect the 4 x M16 safety bolts, nuts,
split pins and tamper proof seals that connect the load plate to the central columns for wear or damage.
Node Plate (Critical Part) - At the bottom end of central columns, visually inspect all of the node plate
fittings and check that all bolts are secure. Do not go underneath an active lift.
Node Plate Safety Bolts (Critical Part) (Consumable)- Visually inspect the 4 x M12 node plate safety
bolts, nuts, split pins and tamper proof seals that connect the node plates to the central columns for wear or
damage.
Recoil Dampers - Visually inspect for any wear or damage and ensure that all bolts, clevis’ and other
fasteners are fully secure. Ensure that there is no sign of any fluid leaking onto the damper rods.
Seat Base Assembly - Visually inspect for any wear or damage and ensure that all bolts and other fasteners
are fully secure.
Suspension - Check the spring condition and test the operation of the springs. Check that the top of the
sliding sleeve is engaged against the compression stops.
Landing Feet - Examine the feet to ensure that they are in good condition after the load test. The feet will
normally recover full height sometime after the load test weight is removed.
Frame and Buoyancy - Visually inspect for any damage and ensure that all bolts and fasteners are tight
and fully secure.
Inspection Data Plate - Check the date of the last load test has been correctly inserted and is indelibly
legible.
Documentation / Report including Photographic Report
To Next Page
Loading...
