Rev 3.1 37 | P a g e
6.3 Parts identification
Each assembly or part is assigned a part number which provides the unique identification of
the part /assembly.
Where material grades and material traceability are deemed to be safety critical these
components will be allocated unique component numbers which will be stamped or etched
as required.
Components that require unique identification are referenced in the parts list.
For bolts, where etching is impractical, batches will be colour coded and a note added to the
mill certificate to identify the colour used.
6.4 Accessories
The following accessories are available from RML to maximise operational effectiveness.
They can be supplied with the carrier or ordered separately.
Strobe Light
Provides greater visibility at night and in poor weather conditions.
High-intensity: light weight, waterproof to 300 m, Flash Rate 50 per
min and also provides 6-mile visibility. C cell battery powered, fitted to
the overhead protection plate in the FROG-XT.
Note: This strobe is not certified for use in hazardous areas. A zoned strobe
light is available on request.
Basket Stretcher
Essential for conducting emergency medical transfers, RML supply a
rigid stretcher that is compatible with the FROG-XT4.
Protective Cover
A silver reflective protective cover which is made of flame resistant
fabric (BS7837) and protects against degradation from UV light and
the weather.
To Next Page
Loading...