Reflex Marine FROG-XT6 - Load Test Procedure

Rev 0.2 24 | P a g e
Inspection Data Plate
An inspection data plate will be issued and attached by the test house, which should show:
i. Tare weight (kg)
ii. Pay load / SWL (kg)
iii. Maximum gross mass (kg)
iv. The load test date (DD/MMM/YYYY)
v. Test load (kg)
vi. The serial number of the FROG-XT: XT6-XXX (where XXX is unit I.D. No)
vii. The model number of the FROG-XT: XT6
viii. Entry into service date (DD/MM/YYYY)
Marker Plate
i. Model number: XT6
ii. Serial number: XT6-XXX (where XXX is unit I.D. No)
iii. Date of manufacture (DD/MM/YYYY)
iv. Tare weight (kg)
v. Pay load / SWL (kg)
vi. Maximum gross load (kg)
vii. Maximum number of passengers (standard & stretcher mode)
Figure 6 FROG-XT Marker Plate