Rev 0.2 28 | P a g e
Frog XT6 Visual Inspection Checklist continued…
Comment / Serial
No./ Colour Code
Check the date of the last examination/ inspection to ensure the unit will remain in compliance with
requirements for at least 6 months. Update data plate to show visual examination has been done.
Stickers - Check that all of the stickers on the unit are in good condition and that none are missing
or damaged. The sticker location drawing can be found in the drawing pack.
Stretcher Fittings – Visually inspect the stretcher fittings to ensure that they are all present and in
good condition.
Storage of FROG - Check the storage cover is in good condition and not showing any signs of UV
or wind degradation.
Storage off the ground , use of spacer chocks whilst not in use
Replacement Parts Stock - Check condition of all associated replacement parts and accessories.
Lifting assemblies should be stored in an appropriate dry place without high visibility cover fitted.
Documentation / Report including Photographic Report
To Next Page
