8. a) A confirmation screen will appear. If the
information is correct, highlight INIT (initialize).
The IR port on the REFLEX™ EZ-COM must now
be pointed at the IR port on the survey instrument.
Press OK. (There is no need to set a survey time.)
b) If the information is incorrect, highlight BACK
and press OK. Keep going back until you reach
the information that is incorrect.
9. Pull back 6 meters. Assemble the instrument and
lower through the bit face. Ensure the landing collar
is sitting in the bit face.
10. Allow 30 seconds for the instrument to settle.
MEASURE is highlighted; press OK to take the shot.
Note: REFLEX™ EZ-COM will hibernate if not used
for 2 minutes. Press the ON button to continue.
3
To Next Page
Loading...
