Need help?Do you have a question about the Reflex Servitec S and is the answer not in the manual?
Highlights potential hazards such as fire risk from ignition sources and burns from hot surfaces.
Guidance on the physical installation process, including safety precautions and connection steps.
Steps for installing the 'DC' degassing lines, including placement and temperature considerations.
Explains the different make-up variants: Magcontrol, Levelcontrol, and None.
Describes the Magcontrol mode for systems with expansion vessels, based on pressure monitoring.
Details the Levelcontrol mode for systems with pressure maintenance stations, based on filling level.
Provides instructions and safety warnings for connecting the device to the electrical supply.
Illustrates the terminal connections for various signals and components of the device.
Lists the prerequisites for the device to be ready for commissioning and initial setup.
Guides on setting the 'Po' minimum operating pressure using the Reflex Control Smart app.
Instructions on how to fill the device with water from the facility system for operation.
Details the steps to start the device in automatic mode after filling and venting.
Describes the automatic mode, including continuous and interval degassing.
To Next Page
General