Wear your safety lanyard at all times.
Never shift the controls with the engine not running.
Control, linkage, and/or sterndrive damage may occur.
For more information, read your engine manufacturer’s
manual before operating the remote control.
Safety Lanyard (Interrupter Switch)
The safety lanyard (used on selected control levers) sometimes called
an interrupter switch is attached to the operator and the remote
control panel. Should the operator lose control of the vessel and
become dislodged from his/her seat or fall overboard, the lanyard will
shut the engine off.
Make sure the lanyard is installed to a part of clothing such as a belt
or belt loop before operating the vessel. Flip the switch to the run
position before starting the engine.
!
WARNING
INTERRUPTER SWITCH MUST BE ATTACHED TO THE OPERATOR
WHILE THE ENGINE IS RUNNING. A QUALIFIED OPERATOR MUST
BE IN CONTROL AT ALL TIMES. READ THE OWNER’S MANUAL
BEFORE USE.
3-35
Engine & Controls
5)
6)
7)
To Next Page
Loading...
