Cosmetic Care & Maintenance
7-37
Checking Power Trim Fluid
ALWAYS CHECK THE OIL LEVEL
WITH THE STERN DRIVE
IN THE “FULL” DOWN OR “IN” POSITION.
1. Place the stern drive unit in the full down position.
2. Observe the oil level. Level must be between the “MIN” or “MAX”
lines on the reservoir.
3. Fill as necessary with Power Trim & Steering Fluid (Merc part #
92-802880Al).
Refi lling The Reservoir
1. Remove the fi ll cap from the reservoir. Fill cap is vented.
2. Add lubricant to bring level to the within the “MIN” and “MAX” lines
on the reservoir. Use Power Trim & Steering Fluid (92- 802880A1).
3. Install the cap.
Changing Power Trim Fluid
1. Power steering fl uid does not require changing unless it becomes
comtaminated with water or debris. Contact a Regal dealer to change
the fl uid.
To Next Page
Loading...
