Regal 2200 - Equipment Operation

Equipment Operation
6-3
2. Find the pressure water breaker switch. Turn the switch to the
“on” position. The pressure water tank will fill the entire system
with fresh water.
3. Open the faucet to allow any air to escape. Close the faucet when
there is a steady stream of water without air. You will hear the
pressure switch shut off the pump indicating the system is full.
4. If your vessel is equipped with a cold water transom shower repeat
step #3. If installed, the transom shower is on the port or starboard
aft deck.
5. After these intitial procedures, fill the system near full with fresh
water. When water exits the vent the system is full.
6. Check for system leaks as evidenced by the pressure water pump
recycling even though no water is being used from the faucet.
CAUTION
!
AVOID PRESSURE PUMP BURN OUT!
DO NOT ACTIVATE THE FRESH WATER
SYSTEM WITH THE WATER TANK EMPTY.
Compass
The compass is set by the manufacturer to ensure its accuracy. If in
doubt it can be zeroed in by using a non-magnetic screwdriver and
turning the compensator screws as recommended. Refer to the compass
manual in the owner’s information pouch. Also, a compass can be
checked while underway for varience and deviation by comparing your
heading with a nautical chart. Compass error is part of the calculation.
Equipment Operation
6-3
2. Find the pressure water breaker switch. Turn the switch to the
“on” position. The pressure water tank will fill the entire system
with fresh water.
3. Open the faucet to allow any air to escape. Close the faucet when
there is a steady stream of water without air. You will hear the
pressure switch shut off the pump indicating the system is full.
4. If your vessel is equipped with a cold water transom shower repeat
step #3. If installed, the transom shower is on the port or starboard
aft deck.
5. After these intitial procedures, fill the system near full with fresh
water. When water exits the vent the system is full.
6. Check for system leaks as evidenced by the pressure water pump
recycling even though no water is being used from the faucet.
CAUTION
!
AVOID PRESSURE PUMP BURN OUT!
DO NOT ACTIVATE THE FRESH WATER
SYSTEM WITH THE WATER TANK EMPTY.
Compass
The compass is set by the manufacturer to ensure its accuracy. If in
doubt it can be zeroed in by using a non-magnetic screwdriver and
turning the compensator screws as recommended. Refer to the compass
manual in the owner’s information pouch. Also, a compass can be
checked while underway for varience and deviation by comparing your
heading with a nautical chart. Compass error is part of the calculation.