CHAPTER 6
6-42
Standard canvas includes a
bimini top with boot, bows
and hardware. Also, side and
aft curtains are available. A
tonneau cover protects the
bow seating area.
To install a typical bimini top,
unzip the top boot and remove
it from the bimini top. Store it
for future use. Unroll the
canvas and install the front
canvas snaps in place. Pull
one of the canvas straps aft
until tight and install the clip
to the eyelet. Install the other
canvas strap to the other side.
Zip the optional windscreen to the bimini top. Then attach the
windscreen to the windshield snaps. It may be necessary to unzip a
portion of it to access the snaps.
Install the port and starboard side
curtains. They should be marked for
easy identification. If not, a visual
inspection will indicate their side.
Install the aft curtain to the bimini
top rear section and zip it in place. It
is a good idea to work out of the boat
by fastening one side of the aft
curtain and working your way out of
the boat. Remember to take down the canvas above idle speeds. Inspect
each canvas piece for dryness especially the clear window glass
material.
Roll
all canvas parts before stowing them.
Install the tonneau (bow) cover to snaps and lower center windshield.
Install tonneau cover pole in canvas receiver and tighten thrumb screw.
Ensure all lanyard pins are fully inserted and tightened completely.
Canvas
LANYARD PIN
CHAPTER 6
6-42
Standard canvas includes a
bimini top with boot, bows
and hardware. Also, side and
aft curtains are available. A
tonneau cover protects the
bow seating area.
To install a typical bimini top,
unzip the top boot and remove
it from the bimini top. Store it
for future use. Unroll the
canvas and install the front
canvas snaps in place. Pull
one of the canvas straps aft
until tight and install the clip
to the eyelet. Install the other
canvas strap to the other side.
Zip the optional windscreen to the bimini top. Then attach the
windscreen to the windshield snaps. It may be necessary to unzip a
portion of it to access the snaps.
Install the port and starboard side
curtains. They should be marked for
easy identification. If not, a visual
inspection will indicate their side.
Install the aft curtain to the bimini
top rear section and zip it in place. It
is a good idea to work out of the boat
by fastening one side of the aft
curtain and working your way out of
the boat. Remember to take down the canvas above idle speeds. Inspect
each canvas piece for dryness especially the clear window glass
material.
Roll
all canvas parts before stowing them.
Install the tonneau (bow) cover to snaps and lower center windshield.
Install tonneau cover pole in canvas receiver and tighten thrumb screw.
Ensure all lanyard pins are fully inserted and tightened completely.
Canvas
LANYARD PIN
To Next Page
Loading...
