6-41
Equipment Operation
Keel Offset. By pressing the “ON/OFF MODE” keypad again dis-
plays the “KL” keel offset setting. It can be set so the depth finder
shows the depth below the transducer or the depth under the keel.
Press the “UP” or “DOWN” arrow keypads to adjust the reading to
the desired depth no further than 19.9 feet.
An example would be if the keel bottom is 3 feet below the trans-
ducer and you desire the depth sounder to read the depth below the
keel, the display should be adjusted to read 3.0 FT.
Note: Once the keel offset is programmed, the shallow and deep
alarms will be energized by the depth under the keel.
Units. Pressing the “ON/OFF MODE” keypad again displays “UN”
on the LCD indicating the units mode.
Press either the up or down arrow keypads to set the units desired to
(FT) feet, (M) meters, or (F) fathoms. Once these units are set, they
will remain the same for all modes. By pressing the “ON/OFF
MODE” keypad again returns the depth finder to normal operation.
6-41
Equipment Operation
Keel Offset. By pressing the “ON/OFF MODE” keypad again dis-
plays the “KL” keel offset setting. It can be set so the depth finder
shows the depth below the transducer or the depth under the keel.
Press the “UP” or “DOWN” arrow keypads to adjust the reading to
the desired depth no further than 19.9 feet.
An example would be if the keel bottom is 3 feet below the trans-
ducer and you desire the depth sounder to read the depth below the
keel, the display should be adjusted to read 3.0 FT.
Note: Once the keel offset is programmed, the shallow and deep
alarms will be energized by the depth under the keel.
Units. Pressing the “ON/OFF MODE” keypad again displays “UN”
on the LCD indicating the units mode.
Press either the up or down arrow keypads to set the units desired to
(FT) feet, (M) meters, or (F) fathoms. Once these units are set, they
will remain the same for all modes. By pressing the “ON/OFF
MODE” keypad again returns the depth finder to normal operation.
To Next Page
Loading...
