CHAPTER 6
6-8
Berth Set-Up
On the 2250, the berth cushions can be set up to make a berth. Start
by inserting the cushion support bar in the two support brackets. Make
sure the bar is seated. Next, remove the port and starboard backrests.
Install them as shown in the illustration. Finally, place the filler cushion
between the two backrest cushions to fill the gap. Reverse the process
to disassemble the berth.
CUSHION SUPPORT BAR
FILLER CUSHION
STBD. FWD. BACKREST
PORT FWD. BACKREST
TYPICAL BERTH
2250
Cockpit Table
To use the optional teak table, simply insert the tube in the floor
receiver and position the table securely to the top of the tube. Rock
the table back and forth to make sure it is seated. Use 2 coats of teak
oil as needed to keep the table surface well oiled. Wipe with a clean
rag. Wait 30 minutes between teak oil coatings.
CHAPTER 6
6-8
Berth Set-Up
On the 2250, the berth cushions can be set up to make a berth. Start
by inserting the cushion support bar in the two support brackets. Make
sure the bar is seated. Next, remove the port and starboard backrests.
Install them as shown in the illustration. Finally, place the filler cushion
between the two backrest cushions to fill the gap. Reverse the process
to disassemble the berth.
CUSHION SUPPORT BAR
FILLER CUSHION
STBD. FWD. BACKREST
PORT FWD. BACKREST
TYPICAL BERTH
2250
Cockpit Table
To use the optional teak table, simply insert the tube in the floor
receiver and position the table securely to the top of the tube. Rock
the table back and forth to make sure it is seated. Use 2 coats of teak
oil as needed to keep the table surface well oiled. Wipe with a clean
rag. Wait 30 minutes between teak oil coatings.
To Next Page
Loading...
