Regal 2200 - Page 176

6-43
Equipment Operation
The cockpit cover shown above installs over the windshield and snaps
to the deck. To install the cockpit cover, note that on the bow end of
the cover there is a seam on the inside which separates the port and
starboard sides. Align this seam with the center snap below the
windshield. Complete snapping the canvas to the outside and then
down each gunnel to admidships.Your boat may have several cockpit
poles. Their purpose is to keep the canvas tight. Notice on the
underside of the cover there are areas of reinforced canvas material.
These are for the cockpit cover poles. This pole(s) is adjustable by
opening it to the desired length and tightening the thumb screw. You
may find it helpful to mark the poles so you can install the poles in
the same spot each time. Continue to snap the cockpit cover to the
deck snaps. When you reach the rear corner leave enough room to
allow a safe exit.
TYPICAL COCKPIT COVER
Cockpit Cover
6-43
Equipment Operation
The cockpit cover shown above installs over the windshield and snaps
to the deck. To install the cockpit cover, note that on the bow end of
the cover there is a seam on the inside which separates the port and
starboard sides. Align this seam with the center snap below the
windshield. Complete snapping the canvas to the outside and then
down each gunnel to admidships.Your boat may have several cockpit
poles. Their purpose is to keep the canvas tight. Notice on the
underside of the cover there are areas of reinforced canvas material.
These are for the cockpit cover poles. This pole(s) is adjustable by
opening it to the desired length and tightening the thumb screw. You
may find it helpful to mark the poles so you can install the poles in
the same spot each time. Continue to snap the cockpit cover to the
deck snaps. When you reach the rear corner leave enough room to
allow a safe exit.
TYPICAL COCKPIT COVER
Cockpit Cover