Regal 2200 - Page 180

Equipment Operation
6. Hold the rocker switch on for 45 seconds. Turn the engine off and
then release the switch.
7. Check the reservoir; the fluid level should have dropped 1/4”.
If the reservoir does not drop 1/4” it may be necessary to repeat
steps 1-6. Run the engine at 1500-2000 rpm”s to help begin the fluid
flow. For normal operation, run engine at idle.
8. If the fluid is still not flowing from the reservoir, check as follows.
a. Hoses for knicks and leaking clamps.
b. Check the vent hole in the reservoir cap for blockage.
c. Check that the solenoid opens when the switch is on and key is on
run.
d. Check the fuse.
e. Check the solenoid connection.
f. Check for a secure ground connection.
6-47
Equipment Operation
6. Hold the rocker switch on for 45 seconds. Turn the engine off and
then release the switch.
7. Check the reservoir; the fluid level should have dropped 1/4”.
If the reservoir does not drop 1/4” it may be necessary to repeat
steps 1-6. Run the engine at 1500-2000 rpm”s to help begin the fluid
flow. For normal operation, run engine at idle.
8. If the fluid is still not flowing from the reservoir, check as follows.
a. Hoses for knicks and leaking clamps.
b. Check the vent hole in the reservoir cap for blockage.
c. Check that the solenoid opens when the switch is on and key is on
run.
d. Check the fuse.
e. Check the solenoid connection.
f. Check for a secure ground connection.
6-47