Regal 2200 - Page 83

CHAPTER 3
3-14
You will hear a distinct sound and will “feel” the remote control in
the detended neutral position. If you turn the key to the “start”
position and the engine starter doesn’t crank over the engine make
sure the remote control is in the detented neutral position.
Remember these points when shifting :
1. Do not shift quickly from forward to reverse gear postitions.
Drive system damage may occur.
2. Do not “pump” the throttle in neutral or flooding will result.
The same thing will happen if you keep pumping the automobile
accelerator pedal. Today’s engines use an enrichment valve system
that requires very little starting throttle.
3. Do not try to shift into forward or revese gear at high rpm’s.
Personal injury, drive system or property damage may result.
4. Only use idle throttle positions when docking or maneuvering in
tight quarters.
5. Wear your safety lanyard at all times.
6. Never shift the controls with the engine not running. Control,
inkage and or stern drive damage may occur.
7. For more information read your engine manufacturer’s manual
before operating the remote control.
CHAPTER 3
3-14
You will hear a distinct sound and will “feel” the remote control in
the detended neutral position. If you turn the key to the “start”
position and the engine starter doesn’t crank over the engine make
sure the remote control is in the detented neutral position.
Remember these points when shifting :
1. Do not shift quickly from forward to reverse gear postitions.
Drive system damage may occur.
2. Do not “pump” the throttle in neutral or flooding will result.
The same thing will happen if you keep pumping the automobile
accelerator pedal. Today’s engines use an enrichment valve system
that requires very little starting throttle.
3. Do not try to shift into forward or revese gear at high rpm’s.
Personal injury, drive system or property damage may result.
4. Only use idle throttle positions when docking or maneuvering in
tight quarters.
5. Wear your safety lanyard at all times.
6. Never shift the controls with the engine not running. Control,
inkage and or stern drive damage may occur.
7. For more information read your engine manufacturer’s manual
before operating the remote control.