Need help?Do you have a question about the REMEHA Quinta 115 and is the answer not in the manual?
General| Model | Quinta 115 |
|---|---|
| Category | Boiler |
| Fuel Type | Natural Gas / LPG |
| Weight | 98 kg |
| Boiler Type | Condensing |
| Installation Type | Wall Mounted |
Details the physical arrangement of components within the boiler.
Explains the combustion process, heat exchange, and condensation mechanism.
Provides detailed physical measurements and diagrams of the boiler unit.
Lists key specifications including output, weight, noise, and operational parameters.
Outlines the main features, materials, and design aspects of the boiler.
States the boiler's annual efficiency rating.
Details the efficiency of heat transfer to the water.
Introduces the boiler's control interface, access levels, and general operation.
Illustrates the arrangement of buttons, displays, and indicators on the control panel.
Explains dual-functionality of control panel keys in operating mode.
Describes how the two-digit display shows larger numbers using dots.
Details the procedure for adjusting the desired water flow temperature.
Explains how to configure the pump's run-on time for heating.
Describes how to set the domestic hot water temperature.
Explains how to select and configure the boiler's operational control mode.
Sets the maximum operating temperature before shutdown.
Sets the maximum fan speed for full load heating.
Sets the fan speed for part load operation.
Defines the temperature difference at which modulation begins.
Sets the temperature difference for DHW demand.
Configures the duration the boiler operates at part load after startup.
Sets the maximum off-time following a control stop.
Defines the flow temperature range for analog signal inputs.
Covers general installation compliance, regulations, and engineer qualifications.
Provides guidance on boiler placement and required clearances for installation.
Details requirements for flue gas evacuation and air intake systems.
Lists CE classifications for various flue gas discharge configurations.
Specifies materials and installation methods for flue and air supply components.
Describes the installation of a conventional flue system for a single boiler.
Details the installation of a room sealed flue system for a single boiler.
Explains considerations for installing the boiler in varied pressure zone environments.
Provides instructions for the safe discharge of condensate and AAV relief.
Outlines recommended water treatment practices for the heating system.
Details the correct procedure for connecting the gas supply to the boiler.
Introduces the suitability of the boiler for cascade and modular configurations.
Explains the components and benefits of the Remeha Quinta cascade system.
Provides an overview of the boiler's electronic control and safety systems.
Lists the electrical supply, rating, and control unit specifications.
Specifies the required permanent single-phase power supply voltage and rating.
Details the specifications and components within the boiler's control box.
Identifies the types and ratings of fuses used in the boiler's electrical system.
Explains how electronic sensors manage boiler flow and return temperatures.
Describes the safety mechanism that prevents overheating.
Details the system that protects against insufficient water flow or levels.
Information on making external connections via the terminal strip.
Explains the use of OpenTherm and other two-wire controls for optimized operation.
Details how to use analog signals for boiler heat output modulation.
Describes how to implement simple on/off control for the boiler.
Explains the setup for two-stage high and low firing control.
Covers DHW temperature sensing and control options.
Explains how primary flow is managed for DHW production.
Provides a step-by-step guide for initial boiler startup and checks.
Explains procedures for temporary and permanent boiler shutdown.
Outlines a systematic approach for diagnosing and resolving boiler faults.
Explains how to interpret and record error codes for troubleshooting.
General advice on routine maintenance and service by qualified engineers.
Details the procedures for annual inspection, including combustion checks.
Instructions for cleaning the boiler's fan assembly.
Steps for cleaning the venturi component.
Procedure for cleaning the main heat exchanger unit.
Instructions for cleaning the burner assembly using compressed air.
Guidance on cleaning or replacing the ignition and ionisation electrode.
Instructions for cleaning the inspection glass.
To Next Page