Why is the outside temperature sensor not detected on my REMEHA Quinta Ace 115?
If the outside temperature sensor was expected but not detected on your REMEHA Boiler, connect the sensor or connect the sensor correctly.
Why is the Room Temperature sensor not detected on my REMEHA Boiler?
If the room temperature sensor was expected but not detected on your REMEHA Boiler, connect the sensor or connect the sensor correctly.
How to fix poor combustion in REMEHA Boiler?
Poor combustion in your REMEHA Boiler can stem from several causes. Here's what to check: * Purge the gas supply to remove air if there's a configuration error. * Ensure the gas tap is properly open if there's no flame during operation. * Check the operation and setting of the gas valve unit if there's no ionization current. * Verify that the air inlet and flue gas discharge flues are not blocked. * Confirm that there is no recirculation of flue gases.
What to do if Functional device has been disconnected in REMEHA Quinta Ace 115 Boiler?
If a functional device has been disconnected from your REMEHA Boiler, check the wiring and connectors if the SCB is not found. If the SCB is faulty, replace it.
What causes Gas Valve Control unit communication exceeding feedback time in REMEHA Quinta Ace 115 Boiler?
If the Gas Valve Control unit communication has exceeded feedback time on your REMEHA Boiler, it may be due to a communication error with the security kernel. Try restarting the boiler. If the problem persists, consider replacing the CU-GH.
What does Communication Error occured mean in REMEHA Boiler?
If a Communication Error occurred in your REMEHA Boiler, it could be due to a communication error with the security kernel. In this case, restart the boiler. If the problem persists, replace the CU-GH.
What should I do if Safety parameters level 2, 3, 4 are not correct or missing in REMEHA Quinta Ace 115?
If the safety parameters level 2, 3, or 4 are not correct or missing in your REMEHA Boiler, it may be due to a parameter error within the security kernel. Try restarting the boiler. If the issue persists, consider replacing the CU-GH.
What causes Gas Valve Control internal blocking in REMEHA Quinta Ace 115?
If a Gas Valve Control internal blocking occurred in your REMEHA Boiler, it could be due to a Security kernel error. Try restarting the boiler. If the problem persists, replace the CU-GH.
What causes No valid data from CU to GVC received error in REMEHA Boiler?
If no valid data from CU to GVC is received in your REMEHA Boiler, it may be due to a communication error with the CU-GH. Restart the boiler.
What to do if Uncritical device has been disconnected in REMEHA Quinta Ace 115 Boiler?
If an uncritical device has been disconnected from your REMEHA Boiler, check the wiring and connectors if the SCB is not found. If the SCB is faulty, replace it.
General| Model | Quinta Ace 115 |
|---|---|
| Category | Boiler |
| Output | 115 kW |
| Fuel Type | Natural Gas |
| Installation Type | Wall-mounted |
Safety guidelines for installers and end-users regarding gas and flue gas.
Guidelines for selecting installation location and adhering to regulations.
Specifies requirements for connecting water, gas, and flue gas systems.
Procedures for connecting gas, flue gas, and air supply components.
Steps for initial boiler commissioning, including gas settings and adjustments.
Explains different types of error codes, warnings, and their meanings.
To Next Page
