25
STEP 8:
CLEANING AND STORAGE
Allow the unit to cool completely.
After each session, and once the
device is turned o, remove the Power
Cord from the device and wall socket
before cleaning.
Use a clean, lint-free cloth (one is
provided with the unit) or a cotton swab
to gently wipe the Flash Window area. It’s
especially important to clean the Flash
Window, Treatment Cap, and the Skin
Tone Tester. If needed, you can
dampen the cloth or cotton swab with
isopropyl alcohol.
Allow the device to dry completely before
using again. If it becomes necessary to
clean the Base Unit or the Hand Piece, use
a lint-free cloth dampened with water to
wipe away dirt or debris.
DO NOT place any part of the device
in water or other liquids. If any part of
the device gets wet, DO NOT USE, and
contact Customer Service. As with any
electrical device, a wet device could cause
electrocution or electric shock.
To Next Page
Loading...
