EasyManuals Logo

REMKO ML 263 DC User Manual

REMKO ML 263 DC
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
1. Press the "MODE" key to select "Dehumidifi-
cation" mode.
2. It is not possible to set a temperature here.
3. Press the "ON/OFF" key to switch on the air
conditioning unit.
1
3
2
Fig. 18: "Dehumidification" mode
In "Dehumidification" mode, it is not possible to
set the fan speed. This is already controlled
automatically.
"Timer" mode
Press the "TIMER ON" key to set the "Auto on"
time and the "TIMER OFF" key to set the "Auto off"
time for the unit.
Setting the "Auto on" time
1. Press the "TIMER ON" key. The remote con-
trol shows "TIMER ON", the last "Auto on"
time setting and the symbol "H" appears on
the display. The unit is now ready to reset the
"Auto on" time and to start "TIMER ON"
mode.
2. Press the "TIMER ON" key again to set the
desired "Auto on" time. Each time the key is
pressed, the time is increased by half an
hour between 0 and 10 hours, and by an
hour between 10 and 24 hours.
3. Once these settings have been made, there
is a one second delay before the remote con-
trol transmits the signal to the indoor unit.
Then, after approx. two seconds, the "H"
symbol disappears from the LCD display,
and the set temperature appears again on
the display.
2
1
Fig. 19: "Timer" mode
19

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the REMKO ML 263 DC and is the answer not in the manual?

REMKO ML 263 DC Specifications

General IconGeneral
BrandREMKO
ModelML 263 DC
CategoryAir Conditioner
LanguageEnglish

Related product manuals