Angular tightening wrench
14 mm hexagonal wrench
TOP AND FRONT OF ENGINE
Timing belt
11
ESSENTIAL SPECIAL TOOLS
Mot. 799-01 Tool for immobilising pinions for
toothed timing belt
Mot. 1054 Top dead centre pin
Mot. 1509 Tool for immobilising camshaft
pulleys
Mot. 1509-01 Accessory for Mot. 1509
Mot. 1512 Tool for fitting the exhaust
camshaft seal
Mot. 1517 Tool for fitting the inlet camshaft
seal
Mot. 1496 Tool for setting camshafts
ESSENTIAL EQUIPMENT
There are two very distinct procedures for setting
the timing.
FIRST PROCEDURE
This is applied in the event of replacement of any
components which require slackening of the ex-
haust camshaft pulley and of the timing inlet
camshaft phase shifter.
During this operation, it is essential to change:
- the exhaust camshaft pulley nut,
- the inlet camshaft phase shifter bolt,
- the phase shifter camshaft seal,
- the phase shifter blanking piece seal.
11-1
To Next Page
Loading...
