AUTOMATIC TRANSMISSION
Filling - Levels
23
FILLING
Filling is via hole (D).
Use a funnel with 15/100 filter to prevent the in-
troduction of impurities.
FILLING PROCEDURE
1-Place the vehicle on level ground.
2-Fill the automatic transmission with 3.5 litres
of new oil.
3-Run the engine at idle.
4-Connect the XR25, enter:
D14then # 0 4
5-When a temperature of 60°C ± 1°C is rea-
ched, open the top-up plug.
6-Position a receptacle to recover at least 0.1 li-
tres of excess oil and wait until the oil flows
drop by drop.
14828R
13792S
7-Close the top-up plug.
PROCEDURE FOR CHECKING THE LEVEL OTHER
THAN DURING FILLING OPERATIONS
It is ESSENTIAL to check the level in accordance
with the procedure described below;
1-Place the vehicle on level ground.
2-Fill the automatic transmission with 0.5 litres
of new oil.
3-Run the engine at idle. Carry out operations
4, 5 and 6 described above.
If the oil does not flow or if the quantity which
can be added is less than 0.1 litres. stop the en-
gine, add 0.5 litres, allow the transmission to cool
to 50°C then repeat operations 3-4-5-6.
IMPORTANT: In the case of an oil change, the
electronic oil age counter (inside the computer)
must be reset to zero. Enter the date of draining
using command G74*.
23-5
To Next Page
Loading...
