AUTOMATIC TRANSMISSION
Differential outlet seal
23
ESSENTIAL SPECIAL TOOLS
B. Vi. 1459 Tool for fitting the right-hand driveshaft seal
B. Vi. 1460 Tool for fitting the left-hand driveshaft seal
To change an differential outlet seal, the corre-
sponding driveshaft must be removed.
REMOVAL
Place the vehicle on a two post lift.
Disconnect the battery.
Drain the automatic transmission via plug (A).
Remove the faulty differential outlet seal using a
screwdriver or a hook taking care not the scratch
the surfaces with which it is in contact.
Take care not to let the seal spring fall into the
automatic transmission.
REFITTING
The seal is fitted using tool B. Vi. 1459 or B. Vi.
1460.
Guide the assembly until the tool is in contact
with the automatic transmission casing.
Refit in the reverse order to removal.
TIGHTEN THE SCREWS, NUTS, BOLTS TO THE
SPECIFIED TORQUES.
Fill the automatic transmission and check the level
(refer to the relevant section).
13791R1
TIGHTENING TORQUE (in daN.m)
Brake caliper bolt 3.5
Lower ball joint nut 6.5
Shock absorber base bolt 20
Wheel bolts 10
Steering ball joint nut 4
Drain plug 2.5
23-14
To Next Page
Loading...
