AUTOMATIC TRANSMISSION
Automatic transmission (Removal - Refitting)
23
ESSENTIAL SPECIAL TOOLS
T. Av. 476 Tool for extracting ball joints
ESSENTIAL EQUIPMENT
Engine support stand
Component jack
TIGHTENING TORQUES (in daN.m)
Transmission nut 33
Brake caliper bolt 3.5
Lower ball joint nut 6.5
Shock absorber base bolt 20
Engine tie-bar bolt 5.5
Gearbox surround and starter bolt 4.4
Suspensded support on gearbox nut 6
Wheel bolts 10
Steering ball joint nut 4
Converter to drive plate mounting nut 3
Exchanger mounting bolt 5
Modular connector support bolt 2
REMOVAL
Place the vehicle on a two post lift.
Disconnect the battery.
Remove the air intake pipe.
14829-1R
Disconnect:
- the ball joint (1) from the multifunction switch
cable,
- the multifunction switch cable (2) releasing
the cable sleeve stop.
NOTE: do not move the orange ring during this
operation. It is possible that this may break on
removal or refitting. If appropriate, do not
replace the control cable as the absence of this
part does not adversely affect the functionality of
the system.
14852M
23-10
To Next Page
Loading...
