AUTOMATIC TRANSMISSION
Automatic transmission (Removal - Refitting)
23
Disconnect:
- the modular connector (1) freeing the
connector slide,
- the oxygen sensor,
- the speed sensor connector.
IMPORTANT:
Protect the connector by slipping it into a
sealed plastic bag.
14829R
Remove the top dead centre connector.
Fit hose clamps and disconnect the exchanger.
Remove:
- the two half-casings under the engine (2),
- the driveshafts ( see Workshop Repair Manual
MR 315 Section 29)
14833R1
23-11
To Next Page
Loading...
