AUTOMATIC TRANSMISSION
Hydraulic distributor
23
Cover mounting bolt 1
Distributor mounting bolt 0.75
TIGHTENING TORQUES (in daN.m)
REMOVAL
Place the vehicle on a two post lift.
Disconnect the battery.
Drain the automatic transmission (refer to the re-
levant section).
Remove:
- the air filter air intake pipe,
- the power steering pipe mounting bolts (B) ,
- the four hydraulic distributor cover retaining
bolts (A) (warning, oil may flow out).
14783R1
14833R
ESSENTIAL SPECIAL TOOLS
B.Vi. 1462 Plunger shaft adjusting screw
14852M
23-7
To Next Page
Loading...
