Renfert POWER - Cleaning & Maintenance; Disposal Information

en
5 Cleaning / maintenance
Safe functioning of the system is only possible if the lter cartridge is replaced regularly. The replacement
cycles depend on the carbonate hardness of the drinking water, usage, and the blend level set.
We recommend replacing the lter cartridge after 6 months, but no later than after 12 months.
The operator is required to check the system for leaks on a daily basis.
When replacing the lter cartridge, all parts must be checked for contamination and damage. Damaged
parts must be replaced and contamination removed.
If the system is not used for an extended period, the lter cartridge must be replaced.
5.1 Flushing the system
The system must be ushed thoroughly after maintenance work or if it has not been used for an extended
period.
⇒ Run the ushing hose into a suitable container (e.g., a bucket) or into a drain.
⇒ Open the purge valve (5) (OPEN, Fig. 3).
⇒ Turn on the water supply.
⇒ Allow the quantity of water specied in the table below to ow through.
⇒ Close the purge valve (5) (CLOSE, Fig. 4).
Flush volume after 1 week of
stagnation:
Flush volume after 4 weeks of
stagnation:
Filter cartridge M for POWER
steamer water softener
3 liters 15 liters
Filter cartridge L for POWER
steamer water softener
5 liters 25 liters
⇒ Then carry out 3 rinsing cycles using the POWER steamer.
5.2 Spare parts
You can nd wear parts and spare parts in the spare parts list available online at
www.renfert.com/p918.
Enter the following item number: 18460100.
The components excluded from the warranty (wear parts, consumables) are
marked in the spare parts list.
6 Disposal information
Equipment with this symbol may not be disposed of in unsorted domestic waste within the Euro-
pean Union.
Please contact your local authorities for more information on proper disposal.
You can nd out about the current options for return online at www.renfert.com
Subject to change
- 6 -