Renfert Twister evolution - Cleaning and Maintenance

- 8 -
EN
6.3.2 Saving mixing parameter settings temporarily
1. Select mixing parameter settings.
Press parameter key.
Mixing parameter symbol will appear in the display.
Mixing parameter setting is displayed in large-scale characters for approx. 4 sec. or until another key is pressed.
2. Set value.
Turn the control knob to change the value.
If the parameter key is not pressed again then the value will only be temporarily saved and will only be applied to the
next mixing process. Once this process has been completed, the previously programmed values will again apply.
$Q\SDUDPHWHUVZKLFKDUHFKDQJHGGXULQJWKHPL[LQJSURFHVVDOVRRQO\DSSO\WRWKHFXUUHQWF\FOH$WWKH
HQGRIWKLVF\FOHWKHSUHYLRXVO\SURJUDPPHGYDOXHVZLOODJDLQ
DSSO\
6.4 Premix Function
<RXFDQFKRRVHWRDFWLYDWHRQHRIWZRGLIIHUHQWSUHPL[LQJIXQFWLRQV
Premix function for plaster (26).
Premix function for investment materials (27).
When one function is activated, the other is automatically deactivated. The pre-
mixing process for both functions lasts no more than approx. 25 sec. Depending
on the amount and type of mixture in question, a good mixing result can also be
obtained from a shorter premixing process.
If a premixing function is activated in a
program then its symbol will appear in the display.
6.4.1 Activate premixing function
The process for the activation and permanent or temporary storage of the premixing
function is the same as that for changing a mixing parameter setting.
2QO\WKHIROORZLQJYDOXHVFDQEHVHWIRUSUHPL[LQJ
 3UHPL[LQJGHDFWLYDWHG
 VHFSUHPL[LQJ
 VHFSUHPL[LQJ
 VHFSUHPL[LQJ
6.4.2 Deactivating the premixing function
Select premixing function,
7XUQFRQWURONQREXQWLOLVGLVSOD\HGLQODUJHVFDOHFKDUDFWHUV
Press the parameter key for the pre-mixing function again until the acoustic signal can be heard
(after approx. 1 second).
7. Cleaning and Maintenance
Switch off and unplug the appliance before cleaning or servicing!
7.1 Housing
Do not steam clean the appliance.
Do not use solvent-based, aggressive or scouring cleaners.
1. Switch the appliance off.
2. Disconnect from mains.
3. Wipe housing with a damp cloth.
7.2 Seal Surfaces
The following seal surfaces must always be kept clean in order to ensure correct
YDFXXPEXLOWXSDQGWKHVHFXUHUHWHQWLRQRIWKHPL[LQJERZOGXULQJWKHPL[LQJSURFHVV
Seal between the paddle and the bowl (28).
Seal between the appliance and the paddle (29).
7LS
<RXVKRXOGUHJXODUO\FRDWWKHUXEEHUVHDOVZLWK9DVHOLQH7KLVZLOOVLJQL¿FDQWO\LQFUH-
ase their service life and optimize to appliance’s function
¿
J

27
26
¿
J

29
28
EN