To fit the probe module and stylus onto the probe body, carry out the following procedure:
1. Visually examine the mating faces of both the probe module and the probe head for cleanliness;
where necessary, clean the mating surfaces using the CK200 cleaning kit (supplied).
2. Offer up the probe module to the PH20 using the reverse of the method used to remove it
manually. Ensure the three alignment marks on both the probe module and probe body are correctly
aligned, allow the probe module to engage the probe body under magnetic force.
Pa
e 50 of 73PH20 user's
uide
19/12/2012file://C:\TEMP\~hh906A.htm
To Next Page
Loading...
