Renishaw PH20 - PH20 calibration

PH20calibration
The PH20 is not supplied with a datum sphere as standard but Renishaw recommends the use of A-1034-
0026.
Minimum Clearance required for
calibration dimension A (in mm)
Standard force
Module
102.0
Medium force
Module*
102.0
Low force
Module*
102.0
6-way module*
106.0
EM1 module*
152.5
Pa
g
e 59 of 73PH20 user's
g
uide
19/12/2012file://C:\TEMP\~hh906A.htm