To Next Page

To Previous Page

Primo™ system

Interface outputs.....................................................................3-2

SSR outputs specications........................................................3-3

Interface output waveform .............................................................3-3

Signal delays: .......................................................................3-3

Switches SW1 and SW2...............................................................3-4

Switch SW1 output conguration ...................................................3-5

Switch SW2 output conguration ...................................................3-5

Dimensions and specications........................................................4-1

Part setter dimensions ................................................................4-1

Tool setter dimensions ................................................................4-2

Interface dimensions .................................................................4-3

Part setter specication ...............................................................4-4

Typical battery life...............................................................4-4

Tool setter specication ...............................................................4-5

Typical battery life...............................................................4-5

Interface specication.................................................................4-6

System installation..................................................................5-1

Operating envelope ..................................................................5-1

Signal LED .........................................................................5-1

Performance envelopes ...............................................................5-2

Equipment positioning ...........................................................5-2

Preparing the part setter...............................................................5-3

Fitting the stylus ................................................................5-3

Installing the battery .............................................................5-4

Mounting the part setter on a shank.................................................5-5

Part setter stylus on-centre adjustment ..............................................5-6

Preparing the tool setter for use .........................................................5-7

Fitting the stylus, break stem and captive link .........................................5-7

Installing the battery .............................................................5-8

Mounting the tool setter on a machine table ..........................................5-9

Tool setter stylus level setting.....................................................5-10

Preparing the interface for use .........................................................5-12

Mounting bracket (optional) ......................................................5-12

Interface wiring diagram .........................................................5-13

Interface cable ................................................................5-14

Cable specication........................................................5-14

Interface screw torque values.....................................................5-15

Renishaw Primo System User Manual

Questions and Answers: