Name: Renishaw Primo System
Brand: Renishaw
Rating: 4 (1 reviews)

To Next Page

To Previous Page

iii

www.renishaw.com/primo

Calibrating the Primo equipment .......................................................5-16

Why calibrate? ................................................................5-16

Calibrating the part setter and tool setter together.....................................5-16

GoProbe training part calibration ..................................................5-17

Calibrating the part setter only ....................................................5-17

Calibrating in a bored hole or on a turned diameter...............................5-17

Calibrating in a ring gauge or on a datum sphere ................................5-17

Calibrating the probe length ......................................................5-17

Calibrating the tool setter only ...............................................5-18

Part setter and tool setter LED guide ....................................................5-18

Start-up .....................................................................5-18

Acquisition mode ..............................................................5-18

Operational mode (all signals repeat) ..............................................5-19

Errors .......................................................................5-19

Credit transfer mode (part setter only) ..............................................5-19

Interface LED signals ................................................................5-20

Acquisition mode ..............................................................5-21

Operational mode..............................................................5-22

Error states...................................................................5-23

Error codes..............................................................5-24

Flashing codes...........................................................5-24

Interface digital display codes ....................................................5-24

Credit codes.............................................................5-24

Acquisition method ..................................................................5-25

Part setter....................................................................5-25

Tool setter....................................................................5-27

Installing the credit token cassette ......................................................5-29

Changing the credit token.............................................................5-30

Credit transfer......................................................................5-32

Maintenance .......................................................................6-1

Introduction.........................................................................6-1

Cleaning the equipment ...............................................................6-1

Changing the battery .................................................................6-2

Part setter.....................................................................6-2

Tool setter.....................................................................6-3

Interface cover ......................................................................6-5

Removing the interface cover......................................................6-5

Routine tool setter maintenance.........................................................6-6

Renishaw Primo System User Manual

Questions and Answers: