Need help?Do you have a question about the Renishaw TONiC RESM20 and is the answer not in the manual?
General| Brand | Renishaw |
|---|---|
| Model | TONiC RESM20 |
| Category | Media Converter |
| Language | English |
Details copyright, reproduction rights, and permissions for the document.
Lists registered trade marks and relevant patents for encoder systems.
Covers exclusions of liability and warranty terms and conditions.
Information on FCC rules, REACH, and WEEE recycling.
Provides visual guides and text on proper handling to prevent contamination.
Lists compatible cleaning solvents for RESM20 rings and readheads.
Details storage, operating, and humidity limits for the encoder system.
Describes the functions of the CAL button for calibration and AGC control.
Compares taper and interference mounting methods for RESM20 rings.
Details recommended shaft roundness and taper diameters for mounting.
Provides step-by-step instructions for mounting the RESM20 ring using taper method.
Instructions for inserting the remaining screws for taper mounting.
Details final screw tightening and radial displacement checks.
Details steps for cleaning, placing, and tightening the RESM20 ring.
Guide to connecting the readhead, interface, and powering up the system.
Explains the process for calibrating the encoder system.
Instructions for plugging the readhead cable into the Ti/TD interface.
Procedure for safely removing the readhead connector from the interface.
Specifies which T20x1 readhead models are compatible with RESM20 ring sizes.
Describes the integrated IN-TRAC™ reference mark location.
Details the necessary specifications for mounting brackets.
Guides readhead alignment and explains LED indicators for setup.
Ensures optimal conditions and settings before starting calibration.
Details the two-step process for calibrating incremental and reference signals.
Explains how to exit the calibration routine manually.
Procedure to reset the system to its original factory settings.
Instructions for switching Automatic Gain Control on or off.
Details the digital signal types, forms, and pin assignments.
Describes analogue signal types, forms, and relevant parameters.
Lists maximum operating speeds for different clock output options.
Formula to convert linear speed to angular speed based on ring diameter.
Guidelines for proper grounding and shielding of the system.
Details signal termination methods and TD interface resolution switching.
Illustrates the form and characteristics of digital output signals.
Shows the waveforms and characteristics of analogue output signals.
Details operating conditions, sealing, mass, vibration, and cable specs.
Provides specifications for the RESM20 ring material and thermal expansion.
To Next Page
