Renkforce RF-AP-N300Mini - LAN Network Configuration

33
III-3-3. LAN
You can configure your Local Area Network (LAN) on this page. Set the device to
automatically obtain an IP address from your router or assign an IP address manually.
You can access the browser based configuration interface
using the device’s IP address instead of using the URL
http://renkforce.setup.
IP Address
Specify the IP address here. This IP address will be
assigned to the EW-7476RPC and will replace the
default IP address.
Subnet Mask
Specify a subnet mask. The default value is
255.255.255.0
Default Gateway
Address
Enter a default gateway address.
DNS Address
Enter a DNS address.