Renkforce RF-AP-N300Mini - LED Status Indicators

2
I-3. LED Status
All LEDs are disabled in green mode. The best signal strength is 60 – 80%
since above 80% is likely too close to your router for the extender to be
effective.
LED
Color
Status
Description
Signal
5GHz
Blue
On
Excellent location.
Signal strength: 60 – 80%
Slow
Flashing
Good location.
Signal strength: 40 – 60% & 80 - 100%
Quick
Flashing
Poor location.
Signal strength: Below 40%
Off
No signal detected.
Signal
2.4GHz
Blue
On
Excellent location.
Signal strength: 60 – 80%
Slow
Flashing
Good location.
Signal strength: 40 – 60% & 80 - 100%
Quick
Flashing
Poor location.
Signal strength: Below 40%
Off
No signal detected.
Cross
Band
Green
On
Cross band enabled.
Off
Cross band disabled.
Power
Green
On
Extender is on.
Flashing
Resetting to factory default settings, or system is
booting up.
Off
Extender is off.
WPS
Green
On
WPS connection established (LED will remain on for 30
seconds to indicate a successful connection).
Flashing
WPS in progress (waiting for another WPS device).
Off
No WPS in progress.
LAN
Green
On
LAN port connected.
Flashing
LAN activity (transferring or receiving data).
Off
LAN port not connected.