Renogy ONE M1 - Page 18

18
Preparation
6. Tear off the mounting template.
7. Remove the base cover of
Renogy ONE.
UP
8. Put the protruding part
of the base cover into
the installation hole (in
a direction and position
as shown in Figure
1.1.7), and use a Phillips
screwdriver to fasten the
base cover with four M4
mounting screws through
the mounting hole.
NOT
E
z
That screws are driven in straight into the mounting holes to ensure the base cover perfectly
fits into Renogy ONE.
z
Ensure that the base cover of Renogy ONE is firmly mounted to the wall to prevent it from
falling off.
Required Tools Inspection Mounting Location