31
Inspect the Rover Boost from time to time to ensure proper performance. For best controller performance:
1.Check the wiring going into the controller from the PV side and BATT side. Make sure there
is no wire damage or heavy exposure wear on the wiring
2.Tighten all terminals to ensure a secure connection and avoid added any resistance and heat build-up.
3.Inspect the Rover Bost for any external damage, environmental damage, or corrosion
4.Ensure PV array does not exceed the voltages designated for 36V and 48V battery charging.
5.Clean the controller as required with a cloth.
Maintenance
To Next Page
Loading...
Need help?
General
