Resol DeltaSol AL EHE - 7 RCTT Remote Control; Remote Activation of Functions

33
en
7 RCTT Remote control (accessory)
The RCTT Remote control enables rapid heat-up activation via the button with-
out having to access the controller menu. It is connected to the controller with a
3-wire cable (see page 6).
If the button of the RCTT is pressed, rapid heat-up will be activated on the con-
troller. If rapid heat-up is already active, it will be deactivated.
If rapid heat-up is active on the controller, the LED of the RCTT will be perma-
nently red.
If rapid heat-up is not possible, because the temperature at sensor S3 has exceeded
the switch-off temperature BH F, the LED of the RCTT will briey ash 3 times.
In the case of a sensor fault, the LED of the RCTT will be ashing continuously.
The RCTT Remote control has to be connected to the controller according to the
installation instructions mentioned in the RCTT Remote control manual.