Retrotec DM32 - Set the [Default @ Pressure]

Page 36 of 91
© Retrotec 2017
Figure 41: Set [Area] using metric units when Result is displayed in metric units
The choice of metric or imperial for “Volume” units follows the last chosen “Flow” or other Result using
area.
Figure 42: Set [Volume] using metric units when other Results are displayed in metric units
4.5 Set the [Default @ Pressure]
If the [Set Speed] function is used and @Pressure “is On”, the [Default @ Pressure] that is chosen with this
Setting will be the reference pressure for the Result displayed on [Channel B] that is extrapolated and
displayed (see section 3.3.10)